Button Turnbukle

The BTB is a great tensioning fitting for long runs. Just tighten the closed body turnbuckle and tension your stainless cable with ease.

• Stainless Cable Railing Solutions Approved Fitting
• 316 Grade Stainless Steel
  
• Re - Tension with Ease

Hand Swage Tensioning Terminal

The HSTT is a great stainless fitting for the do it your selfer. Just order your cable strands mechanically swaged on one side and you can do the rest. No errors in measurement just a clean tensioning fitting that will be buried in the aluminum post.

• Stainless Cable Railing Solutions Approved Fitting
• Hand Swage in the Field
• Holds up to 70% of Cable Breaking Strength

Internal Turnbuckle

The INTB is used on very long runs where extra tensioning is needed. These sexy closed bodied stainless turnbuckles are mechanically swaged at the factory. Once installed in your new aluminum cable railing system you can retension with ease.

• Stainless Cable Railing Solutions Approved Fitting
• Great For Long Runs
• Machine Swage or Hand Swage

Threaded Tensioning Machine Swage

The TTMS terminal is a great choice for tensioning runs up to 25 ft long. They slip easily into your aluminum posts and are buried inside. Once tensioned you cut off the excess bolt and cap with a stainless acorn nut for beautiful long lasting finish.

• Stainless Cable Railing Solutions Approved Fitting
• Lengths up to 7" Long
• Machine Swage Only

Versa Ball Turnbuckle

The VBTB is used on stairs where your angle is greater than 30 degrees. Just hog out a larger hole in your aluminum post and the stainless ball will articulate to the angle of your stairs.

• Stainless Cable Railing Solutions Approved Fitting
• Great for Stairs Over 30 Degrees
• Articulates to the Angle of the Stairs